The Onepush scan validates all 3D geometry and recognizes if objects are plates or profiles. Objects that are not validated are highlighted orange and have an issue description; for example ''not solid''.


Fine tune object types on part level. For example a flatbar can be cut as a plate, then change the object type to plate. Or a flatbar can be ordered as profile, then it will be added with length to the profile_purchase_list.


Objects can also be setup as marker. In this case the object name prefix changes to ''MR'' and the object only gives marker lines to the connecting plates.


Choose ''ignored'' if parts can be ruled out because they are redundant.

Did this answer your question?