Orthogonal Plate names
Orthogonal plates are named based on their ortho orientation, position and the grid definition
X orthos
These are oriented in the transverse plane of the ship; the YZ plane

If a plate touches a defined gridframe within gridprecision it is named after the frame
eg F1 or F15
If a plate lies between frames, it is named after the lowest Frame with a suffix of the offset from that frame. The offset is set by the closest side from the previous frame-line
eg F1+200 or F8+349
Y orthos
These are oriented in the longitudinal plane of the ship; the XZ plane

Plates are named by the point farthest from the CenterLine
Longitudinal Portside plates (positive Y value) are named
LP with a suffix of the farthest point form centerline
eg LP1250
Longitudinal Starboard plates (negative Y value) are named
LS with a suffix of the farthest point form centerline
eg LS530
Plates that cross or touch the Longitudinal Centerline are named
LCL
Z orthos
These are oriented in the waterline plane of the ship; the XY plane

Waterline orthogonal Plates are named W with a suffix of the lowest point
eg W3450 or W200